SNMP Managed Ethernet G.shdsl Modem

SNMP/TELNET/CLI Management, Ethernet E1 & V.35 Optional, 2/4wires, G.SHDSL.bis, G.shdsl Modom

SNMP Managed  Ethernet G.shdsl Modem, SHDSL modem

  

FBDSL1000 series G.SHDSL is with standard E1, V.35 or 10/100Mbps Ethernet interfaces integrated. Its transmission distance is extended to 4km by 1-pair twist pair at 2M speed.  FBDSL1000 is designed with 16TC-PAM code according to ITU-T G.991.2 and ITU-T G.994.1, which can improve the transmission performance and economize resource.  

2.Features

Compatible with G.991.2 and G.SHDSL.bis protocol 2 wires or 4 wires optional The distance can extend to 3.7-4km with 0.4mm (AWG26) by the speed under 2Mbps for one-pair device and 4~4.5Km for two-pair device Support ATM ALL5, NAT, PPPoA, PPPoE, RIP protocol * Support up to 5.69Mbps at 2-wire cable or 11.38Mbps at 4-wire cable when set as G.SHDSL.bis protocol 10/100Base-T interface accordant with standard IEEE802.3 and 1Mbytes buffer inserted. MAC address list inserted and 4096 MAC address available. E1 interface accordant with standards as ITU-TG.703G.823 and G.742. DSL speed can be set manually or auto-detect by the DSL line Easy to install and operate. Working preferences by DIP switch and software control. AC110~240V or DC48V power supply optional.

3.Specification3.1.DSLConnector: 4 pins terminalLine Code: TC-PAMRate:192Kbps~ 2048KbpsDistance: 3.8Km   Single Pair             4.2Km   Double PairsNotice: AWG26 (0.4mm)

The following port types describe all the ports in full-configed G.SHDSL Standalone products. E1 Ethernet and V.35 ports are optional, according to users real application. To get detail part number, please refer to Order Information. The E1 Module Card only provides E1 port..

3.2.E1Compliant with ITU-T G.703, G.704, G.823Line Code: HDB3Connector: 75ohm/BNC, 120ohm/RJ45Framed and Unframed is optional

3.3.EthernetCompliant with IEEE802.3, IEEE802.3u, IEEE802.3xConnector: RJ4510/100Mbps auto-sensing, Half/Full duplex auto detectedThe Module Card doesnt provide this port.Note: see 6.4 comments.

3.4.V.35Ratenx64kbpsFlow control: User defineConnector: DB25FThe Module Card doesnt provide this port.Note: see 6.4 comments.

3.5.Management PortConnector: RS232/DB9(for Standalone Products)Connector CONSOLE/RJ45(for Module Card)Setting timeslots, clocking source, alarms, E1/DSL loop back etc.CLI interface, use hyper-terminal to management

3.6.PowerStandalone Products:AC/DC optionalAC: 220V, 50Hz±5%, Waveform Distorting Rate<5%DC: -40V~ -57VPower Consumption  < 10W

Module Card:The power supply comes from the backboard in 4U Machine-FrameDC: 15V/6APower consumption < 10W

SNMP Managed Ethernet G.shdsl Modem